Procedure for connecting the BlueFlasher to the PC and the Blue&Me module to the BlueFlasher system. Please follow the order indicated below to avoid possible short circuits caused by unexpected malfunctions of the Blue&Me module to be repaired.
1
Connect to the power supply and to the PC
Connect the power cable from a stabilized power supply (set at 12V DC and maximum deliverable current) to the jack marked "+12V IN". Connect the USB cable to the connector marked "USB" and then to the PC.
2
Board extraction
Remove the Blue&Me module from the vehicle. Unscrew the screws highlighted in the figure and extract the board.
3
Insert in template
Insert the Blue&Me board, slightly inclined, into the hollow part of the 2 lower supports (highlighted in red in the video). Lower the card until it fits into the fixed supports at the top. (highlighted in green in the video).
The video on the left shows a Blue&Me Lauberhorn (more common), the video on the right shows a Blue&Me present on Chrysler, Freemont and Thema.
4
J-TAG connection
Unscrew the side washers, lower the template until the micro needles touch the Jtag connector of the Blue&Me. The micro needles have an internal spring that allows them to compress. Stop the template in the position shown in the figure (at the end of the video), screwing the side washers back on.
5
Plug the connector
Connect the power cable to the connector on the right of Blueflasher, then attach the other end to the Blue&Me connector as in the sequence shown in the video.
The video on the left shows a Blue&Me Lauberhorn (more common), the video on the right shows a Blue&Me present on Chrysler, Freemont and Thema.