1
Test function selection
Select the test procedure from the menu on the left. Make sure that the Blue&Me module is correctly connected to BlueFlasher via the connector cable.
If you are unsure about the connections, you can always check our connection guide for control units of 1st generation and 2nd generation.The J-TAG connection IS NOT necessary for carrying out the test operations.
2
CAN communication test
The first step is the communication test on the CAN line. Press the "START" button to start the function. The test can take from 20 to 120 seconds to complete.
At the end of the procedure, the program will show the Blue&Me as working (Left image) or not working (Right image).
If the Blue&Me is functioning it will be possible to proceed with the audio test.
3
Audio test
If the functionality test was successful, you can click on the "Start" button to begin the audio test. After a few seconds the Blue&Me module will play a sound.
A window will then open asking the user to confirm if it was possible to hear the sound (Left image). If the audio test is completed, you can then proceed to the speech recognition test (Right image).
4
Voice / Bluetooth test
Click on the "Start" button to start the speech recognition test (Left image). A screen will open, wait a few seconds and press the Windows button (Right image). This corresponds to pressing the Windows button from the car's steering wheel controls. After a few seconds, the Blue&Me guide voice should ask the user to pronounce a command (in the language currently present on the Blue&Me).
It is now possible to navigate in all the Blue & Me functions using voice commands by speaking into the microphone located in the upper right part of Blueflasher. Stand approximately 50cm from the microphone to allow the microphone to properly capture your voice. To test the Bluetooth functionality navigate to the required menu with voice commands and pair a phone. Once satisfied with the test, you can exit the window by pressing the exit button.