ATTENTION: For inexperienced users it is recommended to always follow the guided procedure.
1
Writing function selection
Select the writing procedure from the menu on the left. Make sure that the Blue&Me module is correctly connected to BlueFlasher via connector cable and J-TAG.
If you are unsure about the connections, you can always check our connection guide for control units of 1st generation and 2nd generation.
2
File selection
Press the "WRITE" button (Left image) to open the file selection screen (Right image). Select the memory file you want to write on the NAND memory.
ATTENTION : Make sure that the selected file comes from a memory of the same model as the memory mounted on the Blue&Me card to which you want to write, otherwise the result will ALWAYS be a non-working Blue&Me. It is also recommended that you perform a read operation before writing any file to have a backup file available in case the write operation fails.
3
Wait for the procedure to finish
The program will delete the contents of the memory and then write the selected file in the NAND memory. The writing time varies according to the type of memory present on the Blue&Me board, it is possible to check the progress from the percentage in the progress bar at the bottom of the program.
During the erase procedure it is possible the program will find some bad memory blocks. In that case it is still possible to continue writing, even if the probability of success of the repair and correct operation on the vehicle are lower.